GLF Arduino and Basic Stamp sourcecode 03/21/2018 GLF ---------------------------------------------------------------------------------------------- GLF has been an electronics hobbyist for many years, but until recently experimentation with microprocessors was limited to building peripheral devices such as printer interfaces or EPROM writers. To solve a particular problem in 2008, GLF acquired a Basic Stamp development kit to explore building an embedded microprocessor project (for reading a stellar photometer data stream). GLF spent a limited amount of time and effort on Basic Stamp programming, built the intended project, and let the Stamp code rest a while. In August 2010, GLF began to associate with a creative group of electronics builders, engineers, and general makers of things called LVL1 (Level One) Hackerspace in Louisville, KY. There GLF found a renewed interest in low-cost microcontroller development, mostly centered around AVR microprocessors and the Arduino platform. Arduino has an open hardware design and many "clones" are available for as little as $10 each. GLF took on a variety of projects personally and for LVL1 interest groups using mostly "Diavolino" boards (a cheap Arduino clone). The source code for these boards, like the Stamp, is compiled using a freely available compiler set on a PC (Windows or Linux) and uploaded to the Arduino board, then tested as hardware. GLF has accumulated a variety of end programs and personal or adapted libraries, especially for Arduino. The current GLF source is provided in this release without other support. If you're into Arduinos, it may be useful, even valuable. If not, you can ignore it. In order to actually USE the Arduino or Stamp code, the user would need to acquire the necessary compiler software from Arduino and/or Parallax (Basic Stamp). That is optional for a user of the GLFPE as it is unrelated to Windows or Linux program development. In actual practice, one would locate the source code in a standard, expected location, not the c:\prg source tree. The provided archive puts the Arduino and Stamp code into the prg tree, but the user can move it later (e.g. Arduino libraries go under the Arduino installation treee, Arduino "sketches" go under "My Documents", the Arduino folder).